Charles L Gruby Gruby
Charles L Gruby Gruby
@charlesgruby
Trusted Member
Joined: Apr 15, 2017
Last seen: Apr 10, 2022
Topics: 0 / Replies: 72
Topic
Replies: 6
Views: 327
Reply
RE: Continental O-470 Installation

Thanks for the info Will, sorry it took so long to reply.

2 years ago
Topic
Replies: 11
Views: 721
Reply
RE: Crooked Flight

@lawheelockThanks for the response. i5 years as a member, wow that's a long time. Good to see all you experts hanging in therewhen needed. I wonder wh...

2 years ago
Reply
RE: Crooked Flight

@lawheelock. Larry, I thought I remembered you at that Flyin back in '97. That was a real blast Marcia Gietz (now Marcia Mason) and I did all the leg ...

2 years ago
Reply
RE: Exhaust Muffler Flame Tubes

@lawheelock Thanks Larry. I suspected as much. I had heard that on more than one occasion these things would break up and clog the exhaust outlet caus...

2 years ago
Reply
RE: Exessive Right Rudder Required

John, another thing I thought about. What about a really aft cg? That'll make an airplane fly really strange. Might not be a bad idea to check it out....

2 years ago
Forum
Topic
Replies: 3
Views: 283
Reply
RE: Flying Crooked

John, I answered another post with similar problems. First of all, you must start from a normally rigged airplane. In the Service manual, paragraph...

2 years ago
Forum
Reply
RE: Exessive Right Rudder Required

@dcn6102m I wouldn't worry too much about the ball until I had done the other things I mentioned earlier, then if you really want to check the ball ac...

2 years ago
Forum
Reply
RE: Exessive Right Rudder Required

John, I'm getting to this post rather late, but here's my two cents worth. First of all I'm an A&P, have owned three Stinson's, one dash 3 and two...

2 years ago
Forum
Reply
RE: Aileron pushrod replacement

That would be super, Thanks again.

2 years ago
Forum
Reply
RE: Aileron pushrod replacement

Bill, Thanks-a-heap. I suspected that was the solution, so it was good to hear someone else had done it before. Pictures would be nice if it's not too...

2 years ago
Forum
Reply
RE: Aileron pushrod replacement

There is an inspection hole, but it still doesn't seem possible to be able to get to the end to disconnect it. I'm thinking it's probably doable, but ...

2 years ago
Forum
Topic
Forum
Replies: 7
Views: 255
Page 2 / 5