Reputable Member
Joined: Jun 5, 2019
Last seen: Dec 7, 2022
Topics: 28 / Replies: 254
Reply
RE: Fuel Selector "Both"

Regarding the older 172's, it was added to the POH at some point. I actually had the engine quit once cuz I didn't believe that it could happen, but i...

4 days ago
Reply
RE: Fuel Selector "Both"

Even older Cessna 172's need to be switched to just one tank at altitude and they have a cross over vent line.

5 days ago
Reply
RE: 108-3 - How much useable fuel?

The model 108 looks like it has less dihedral than the 105, but the 105 has around 8 gal that you cannot measure with a dipstick.

3 weeks ago
Reply
RE: HW75/10/10A yokes

Good luck, I think my model 10 yokes look different than a HW-75, or maybe they look different than a model 10A. There may be more than just one yoke ...

4 weeks ago
Forum
Reply
RE: Amperage Gauge-what does it measure?

Plenty of O-470’s came with an alternator. Find an installation (like a Cessna 182) that uses an alternator and use that for approval.

1 month ago
Forum
Reply
RE: -1 Fuel System

Don't forget to make sure there is an electrical jumper wire around the section of rubber hose.

2 months ago
Forum
Reply
RE: Airspeed indicator water in pitot

Cessna uses a small clear plastic bottle with 1/8" pipe thread at the ends. They often fail a static test because of cracks at the ends, so if you bu...

3 months ago
Reply
RE: Generator to Alternator STC or FA info

@taylorrfernandezgmail-com I wouldn't put much hope in flashing the field. That usually only needs to be done when you install a new component, so...

6 months ago
Forum
Reply
RE: Generator to Alternator STC or FA info

@stinsono I thought the generator was an engine accessory? If you have an O-470 already, you should be able to find an approved alternator for that ...

6 months ago
Forum
Reply
6 months ago
Reply
RE: Sensenich Controllable Prop "Governor"

What is the hole spacing? I have a cover plate with 4, 5/16" holes on 2" centers and a gasket. I don't want your old governer!🙃

6 months ago
Reply
RE: Looking for info on where to get the O-235 STC for a Stinson 10A or O-290 info

Lycoming O-235 STC for HW-75, 10 and 10A is SA342SW. The information is on a CD and I probably could email it to you. Mike.

8 months ago
Forum
Reply
RE: Looking for info on where to get the O-235 STC for a Stinson 10A or O-290 info

I have a copy of the STC for an O-235, It's free to all. Give me a few days to get off my ass and find it.

8 months ago
Forum
Reply
RE: .30-under rod bearings for 150 Franklin

@stinsono "Crankshaft reground. pn12345678 bearings installed." I have never seen a lot book entry that said much more than that. A yellow tag ...

10 months ago
Reply
RE: .30-under rod bearings for 150 Franklin

@ed-reading You would think that after going to .030 under during an ovhl, the next time it gets an ovhl it's probably going to need a new crank. ...

10 months ago
Page 1 / 17